Ridgewood, NY & the surrounding area

  • Mon - Fri: 8:00am to 6:00pm

    Sat: 9:00am to 4:00pm

    Sunday: Closed

Plastering & Modeling in Ridgewood, NY

PLASTERING PROBLEMS AND HOW TO SOLVE THEM

Several problems can arise if a plastering job is done incorrectly, but not when you contact Lituma Plastering. Various signs indicate a task not completed with perfection. There can be many reasons that these kind of problems arise. The wall was not prepped properly, plaster was not laid in small sections, incorrect proportions were mixed, all this and many more factors can contribute to problems arising in the plaster. It is very important to tackle them and fix them to prevent any kind of damage in the future, here are some problems that you can spot, and then call us for professional help.

NOT MIXING PROPERLY

This is a very common problem when the project is time-bound. The workers tend to compromise the quality and take shortcuts. It might complete the project in time, but later on, it can cause a lot of issues. The paint might start chipping off, cracks can develop, etc.

NOT LETTING THE PLASTER DRY

The main contributing factor to any messy job is not giving the plaster enough time to bind itself. The plaster needs a good amount of time to be ready for the paint. If not dried completely, it will show up as moisture patches and dampness in the wall.

SURFACE NOT PREPPED

If the surface is not prepped for the paint, it will not allow it to sit properly. Two base coats shall be applied properly and then the paint process shall begin. If neither of these steps are completed without error it can lead to peeling of the paint within a short period.

SHRINKAGE OF PLASTER

When the plaster is drying it starts to shrink, that is when it is binding itself together. If the paint is applied over, it will shrink too. It is advised to make sure that each step is given its own time to lead to the expected results.

SAGGING PLASTER

It is a common problem to witness and spot an untidy job. When the plaster is not applied in small sections or is too thick this is a usual sight to witness. The plaster begins to droop and give a very shabby look to the whole place.

These are some problems that a homeowner can witness but we, Lituma Plastering, are your one-stop solution to resolve the issues. We pay meticulous attention to each detail and make sure to provide you with the best quality. We

  • Use Cutting edge Equipment
  • Hire Professionals With Years Of Experience
  • Make Use Of Proper Techniques
  • Keep The Cost At An All-time Low
  • Prep The Wall Before Plastering
  • Apply Plaster In Thin Layers
  • Try To Keep Moisture At Bay
  • Give The Wall Its Cure Time
  • Perform Each Step With Patience

Put your faith in us and get your plastering fixed by the forerunners of the plastering industry we leave no scope for complaint when we finish a task. Make your abode or office space better by availing of the benefit of our service. Get in touch with our team and see for yourself.